Novel 3D printable powered air purifying respirator for emergency use during PPE shortage of the COVID-19 pandemic: a study protocol and device safety analysis

Nagel, Jorge; Gilbert, Catherine; Duchesne, Juan

OBJECTIVES: To design a low-cost 3D printable powered air-purifying respirator (PAPR) that meets National Institute for Occupational Safety and Health (NIOSH) standard for flow rate and Occupational Safety and Health Administration (OSHA) standard for particle filtration for loose-fitting PAPRs and that can be made with a 3D printer and widely available materials. DESIGN: Detailed description of components, assembly instructions and testing of a novel PAPR design in an academic laboratory following respective protocols. The assembled PAPR must meet NIOSH standards of flow rate, 170 L/min; OSHA fit factor for particle filtration, ≥250 and maintain positive pressure during regular and deep breathing. MAIN OUTCOME MEASURES: The PAPR design was run through a series of tests: air flow (L/min), particle filtration (quantitative and qualitative) and positive pressure measured inside the helmet (mm Hg). RESULTS: Flow rate was 443.32 L/min (NIOSH standard: minimum 170 L/min) and overall fit factor for particle filtration was 1362 (OSHA pass level: ≥500), n=1. The device passed qualitative particle filtration, n=2, and measured peak pressure of 6mm Hg (>0 mm Hg indicates positive pressure) in the helmet, n=1. CONCLUSIONS: The Hygieia PAPR is a low-cost, easily accessible, just-in-time 3D printable PAPR design that meets minimum NIOSH and OSHA standards for flow-rate and particle filtration for loose-fitting PAPR devices to be made and used when industry-made designs are unavailable.